Granite is perhaps the most famous natural stone in Nevada and Utah, thanks to its sturdiness and exquisite looks. The typical cost of fabrication, cost of material and installation ranges somewhere between $70 and $80 per square foot for granite countertops.
Since it is costly, you can’t make blunders during granite countertops installation. Therefore unless you have enough information and expertise, you shouldn’t DIY granite countertop installation. If you do, you might harm the countertop and spend even more in repairs and replacement.
The best decision is to enlist an established stone contractor such as Accent Countertops Company in Nevada and Utah for a problem free and smooth installation.
However, you can help make sure your countertop installation goes smoothly. In this article, we will talk about how you can prepare your kitchen for granite countertop installation.
How to Set up Your Kitchen for Granite Countertop Installation
The following are a couple of steps you can take prior to installing a granite countertop.
Tearing down the Old Kitchen Countertop
Before you replace your old countertops, you first need to eliminate them. Use a knife to separate the old countertop from the surface it is connected to or from the wall. If there are screws joined, you also need to eliminate them to guarantee that the surface is prepared for the granite countertop installation.
Ensure the Surface Is Evened out
The surface of the kitchen cabinet should be evened out to guarantee a protected installation of your new countertop. An evened out surface also reinforces the countertop and guarantees that it is perfect for drawn out use.
The best way to do this is to keep shims beneath the cabinets. The shims will enable you to even out the surface and assist your countertop with fitting impeccably.
Another method is to use plywood which can be placed on the kitchen countertop to have the appropriate level. If you use the plywood method, place the shims beneath the wood for more effectiveness. It is important to keep in mind that if you keep plywood on the countertops then there will be an extra weight and you need to decide whether you are OK with this.
Removing the Plumbing systems
To mount your Nevada and Utah granite countertops, you need to get rid of the current plumbing pipes. This helps in mounting the countertops over the kitchen cabinets appropriately.
To begin with, shut off the water. On the other hand, if you have not installed plumbing yet (as in a full kitchen redesign), you should take time to prep the area. After your granite countertop installation, then you can re-install the plumbing system. This will help your plumber to know the specifications that suit your granite countertops.
Clear the Surfaces
Ensure you clear all dishes and utensils from the installation site to avoid breakage during installation. For the components that are far from the installation site, cover them with a defensive sheet.
Getting the best out of your granite countertop implies setting up the installation area before the process starts. This allows you to get the best outcomes. Remember that granite countertops installation isn’t a DIY kind of project project.
If you need help preparing for your countertop installation, contact Accent Countertops in Nevada and Utah. Our master fabricators and installers are devoted to helping you with the selection and installation of granite at reasonable rates.